- Rhino gas powered post driver replacement parts install#
- Rhino gas powered post driver replacement parts manual#
Hole in CleaninG F an Bracket Clean fan every 500 hours of operation or as needed. Severe burns and electrical shock can occur. SERVICE PROCEDURES Top Cover warnin G: never service heater while it is plugged in, Terminal connected to propane supply, Block operating or hot. Check supply valves (on propane/LP or as needed to remove dust and debris. and electrical shock can occur. Wait ten seconds. OPERATION MAINTENANCE Continued warnin G: never service TO reST arT hea Ter heater while it is plugged in, If safety control stops gas flow to heater, motor connected to propane supply, will continue to run. Plug extension cord into a 1 0 volt/60 the regulator assembl this happens, you may hear a click inside 4. opened slowly, excess-flow check valve 101 to ̀0 feet (30.78 to 61 m) long, use on propane/LP tank will stop gas flow. Open propane/LP supply valve on 51 to 100 feet (15.5 to 30.5 m) long, use propane/LP tank(s) slowly. Follow all local and the Natural Gas and Propane Installation codes when using this heaĮxtension Cord Size Requirement INSTALLATION Up to 50 feet (15 m) long, use 18 AWG Continued rated cord. They are needed to safely op- of Liquefied Petroleum Gas, ANSI/NFPA 58 erate this heater. See Chapter 5 Safety Information section, page of the Standard for Storage and Handling 2. warninG: review and un - Use this heater only with a propane/LP vapor derstand the warnings in the withdrawal supply system. PROPANE SUPPLy INSTALLATION Propane/LP gas and propane/LP tank(s) are to be furnished by the user.
If Handle End Cap Cord heater is damaged, promptly hose/regulator assembly) for storage. Remove all items from carton.
Rhino gas powered post driver replacement parts install#
Keep plastic cover Install cord cleats on side of end caps as shown cap (attached to heater inlet connector and in Figure 3 with screws provided (short). Remove all packing items applied to Cord Cleats heater for shipment.
Small post screws on plastic foot will snap UNPACIN k g into holes in leg extensions. Do not use heater outdoors or in occupied foot opening of fresh, outside air for each Improper replacement parts could cause 100,000 Btu/Hr (105,500 k/j) of rating. heater, provide at least a three-square- Do not substitute or use generic parts. Before using heater must use design-specific parts. Never attach duct work to front or rear of SAFETy INFORMATION heater.
General hazard warninG : Failure to comply with the precautions and instructions provided with this he improper use of heater can cause serious injury.
Rhino gas powered post driver replacement parts manual#
PROPANE/LP CONSTRUCTION FORCED AIR HEATER OWNER’S MANUAL 55,000 BTU MODELS TB100, TB104, TB106, TB110 85,000 BTU MODELS TB102, TB111, TB114 125,000 BTU TB101, TB105, TB107, TB112 170,000 BTU TB103, TB108, TB113 iMPOrT anT: read and understand this manual before assembling, starting or servicing heater.
0 kommentar(er)
